Simplicity 1693407 Especificações descarregar pdf (Página 96)

Solenoid Valves

This section presents the procedures for removal or installation of a

Solenoid Valve. The valves are mounted on either the floor or back of the

electronic enclosure, depending on configuration. Valves are replaced

individually using the valve kit noted in the spare parts section of this

manual.

Description

Voltage dangerous to life exists. Before performing the removal and

installation procedures, it is important that primary AC power to the

Maxum II be turned off from the main circuit breaker. Observe all

plant safety requirements before performing any repair or

maintenance on the Maxum II.

WARNING

The following procedure should be followed for removal and installation

of a Solenoid.

Procedure

Step Procedure

1. Turn off power to the Maxum II at the main circuit breaker.

2. Open electronic enclosure door (using a 4mm (5/32”) Allen

wrench if necessary).

3. Unplug the cable to the solenoid to be replaced, as shown

below.

A5E31405710001 4-17

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 125 126

Sem comentários

Simplicity 1693407 Especificações Página 96